Which latitude belt best describes the middle latitudes?

A 20<sup>o</sup> to 80<sup>o</sup>
B 10<sup>o</sup> to 35<sup>o</sup>
C 20<sup>o</sup> to 35<sup>o</sup>
D 40<sup>o</sup> to 70<sup>o</sup>
E 30<sup>o</sup> to 50<sup>o</sup>

Correct Answer: 30<sup>o</sup> to 50<sup>o</sup>

The middle latitudes (also called the mid-latitudes, sometimes midlatitudes, or moderate latitudes) are a spatial region on Earth located between the latitudes 23°26'22" and 66°33'39" north, and 23°26'22" and 66°33'39" south.
Bissoy MCQ
#General Knowledge #Environmental Science

Related Questions

If in a closed traverse, the sum of the north latitudes is more than the sum of the south latitudes and also the sum of west departures is more than the sum of the east departures, the bearing of the closing line is in the
A NE quadrant
B SE quadrant
C NW quadrant
D SW quadrant
In middle latitudes, which cloud will have the lowest base?
A Cirrostratus
B Stratocumulus
C Altocumulus
D Cirrus
The power transmitted by a belt is maximum when the maximum tension in the belt is _________ of centrifugal tension.
A One-third
B Two-third
C Double
D Three times
The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
A Equal to
B Less than
C Greater than
D None of these
In multi V-belt transmission, if one of the belt is broken, we have to change the
A Broken belt
B Broken belt and its adjacent belts
C All the belts
D There is no need of changing any one as remaining belts can take care of transmission of load
A pulley and belt in a belt drive form a
A Cylindrical pair
B Turning pair
C Rolling pair
D Sliding pair
In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set to
A Reduce vibration
B Reduce slip
C Ensure uniform loading
D Ensure proper alignment
The velocity of the belt for maximum power is (where m = Mass of the belt in kg per meter length)
A $$\frac{{\text{T}}}{3}$$
B $$\frac{{{\text{Tg}}}}{3}$$
C $$\sqrt {\frac{{\text{T}}}{{3{\text{m}}}}} $$
D $$\sqrt {\frac{{3{\text{m}}}}{{\text{T}}}} $$
In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to
A Reduce vibration
B Reduce slip
C Ensure uniform loading
D Ensure proper alignment
The ratio of driving tensions in V-belt drives is __________ flat belt drives.
A Equal to
B sin$$\,\alpha $$ times more than
C sin$$\,\alpha $$ times less than
D cosec$$\,\alpha $$ times more than

Next steps