Which of the following time will normally be determined by the requirements of the device to which the transfer is being made

A Access
B Cycle
C Hold
D Delay
E None of the above

Correct Answer: Hold

Hold time will normally be determined by the requirements of the device to which the transfer is being made. Setup time is defined as the minimum amount of time before the clock's active edge that the data must be stable for it to be latched correctly.
Bissoy MCQ
#Computer Fundamentals #Computer Fundamental Miscellaneous

Related Questions

Which of the following represents examples of an IT input device, output device and storage device respectively ?
A bar code reader, CD drive, projector
B keyboard, monitor, hard disc
C printer, DVD drive, joystick
D printer, mouse, monitor
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
Calculation of mass transfer co-efficient is mostly/normally done using __________ theory.
A Surface renewal
B Film
C Penetration
D None of these
In the human being, normally in which one of the following parts, does the sperm fertilize the ovum?
A Cervix
B Fallopian tube
C Lower part of uterus
D Upper part of uterus
__________ property of a material is determined by the Herbert Pendulum device.
A Hardness
B Tensile
C Toughness
D Compressive
Mistakes made in the requirements analysis stage show up in
A System design
B System development
C System testing
D System implementation
E None of the above
The electronic conveyor-belt system, which Susan Park (A) adapted from a production-line method (B) pioneered by Thomas Langley, reduced the (C) required time being needed of assembling a SmartGadget device (D) from over ten hours to just 120 minutes.
A A
B B
C C
D D
E E
A train travels from New York to Chicago, a distance of approximately 840 miles, at an average rate of 60 miles per hour and arrives in Chicago at 6:00 in the evening , Chicago time . At what hour in the morning, New York City time, did the train depart for Chicago time . At what hour in the morning , New York City time, did the train depart for Chicago ? ( Chicago time is one hour earlier than New York City time.)
A 4 : 00
B 5 : 00
C 6 : 00
D 7 : 00
The vitamin which normally made in the kidneys is
A Vitamin A
B Vitamin E
C Vitamin C
D Vitamin D

Next steps