Related Questions

If 'Δx' represents adherent oxide layer thickness and 't' is time, which of the following curves represents diffusion controlled oxidation kinetics?
Metallurgical Thermodynamics and Kinetics mcq question image
Consider the growth of a microorganism in batch culture. When the substrate concentration is high, the cell density doubles every 0.75 h, the observed substrate yield coefficient is 0.3 g DCW/g, and substrate consumption is allocated towards biosynthesis (60%), maintenance (10%), as well as product formation (30%). The product formation is strictly growth-associated. The batch reactor is inoculated with 0.01 g DCW/L and 10 g/L substrate. Estimate the maximum cell density (after lag phase).
If k is the rate constant for a reaction and T is the absolute temperature in the given figure, the activation energy for the reaction is . . . . . . . . J/K mole.
Metallurgical Thermodynamics and Kinetics mcq question image
Select the correct plot of Gibbs free energy (G) Vs. Temperature (T) for a single component system from the following:
Metallurgical Thermodynamics and Kinetics mcq question image
Wash out (as defined by D = μmax) of a continuous stirred tank fermenter is characterized by (X = biomass, S = substrate concentration in bioreactor, S0 = substrate concentration in feed, P = product concentration in bioreactor).
Uncompetitive inhibition is most noticeable at low substrate concentration and can be overcome at high substrate concentration.
Statement 1: Enzyme reaction is dependent of concentration on enzyme only and not substrate. Statement 2: Do enzymes catalase and peroxidase show residual enzyme activity?
In balanced growth phase of a cell,
P. All components of a cell grow at the same rate.
Q. Specific growth determined by cell number or cell mass would be the same.
R. The growth rate is independent of substrate concentration.
S. The growth rate decreases with decreasing substrate concentration.
The concentration of oxygen at the inner surface of the vessel is maintained at a level C depending on the pressure in the vessel, while the concentration at the outer surface is reduced to zero by the escape of oxygen to the surroundings. A steady state will eventually be reached when the concentration everywhere reaches a constant value. Provided D is independent of concentration there will be a single concentration gradient in the wall and the thickness of the wall is L, the flux is given by________________
In a substrate X catabolic gene promoter you replace the normal histones by your experimental histones – ones with arginine side chains in place of histidine. What will be the effect on the concentration of substrate X against the control?