How many rate are used to calculate wages under Taylor's differential piece rate system?

How many rate are used to calculate wages under Taylor's differential piece rate system? Correct Answer two

Two rate are used to calculate wages under Taylor's differential piece rate system. Taylor's Differential Piece-Rate System was introduced by F.W. Taylor, who believed that the workers should be paid on the basis of their degree of efficiencies.
Bissoy MCQ

Related Questions

A worker is employed in Factory "M" for monthly TA. 10,000 wages. Regular work schedule for every worker is 250 hours a month, For every additional hour of work beyond 240 hours workers receive 1.5 time wages. If the worker works 270 hours in a month what would be his total earning?
A worker is employed in Factory "M" for monthly TA. 10,000 wages, Regular work schedule for every worker is 24 hours a month. For every additional hour of work beyond 24 hours workers receive 1.5 time wages, If the worker work 270 hours in a month what would be his total earning
A garments factory employs 3 categories of workers K, M and N. The efficiency of the 3 categories of workers to do a specific task is in the ratio of 3 : 5 : 6 respectively and the factory employs 15 of category K, 12 of category M and 3 of category N. If the total wages paid to the entire group of 30 workers is Tk. 492 per hour, what will be the wages earned by a category N worker for an 8-hour day?
The average daily wages of female worker in a factory is Tk. 30 and that of male workers is Tk.42 .If the average wages of all the woekers is Tk.37, what is the ratio of male to female workers ?
Three categories of employees get wages in the ratio of 1 : 2 : 3. If they get increments of 5%, 10% and 15% respectively, what will be the new ratio of their wages?
A board of length L feet is cut into two pieces such that the length of one piece is 1 foot more than twice the length of the other piece. Which of the following is the length, in feet, of the longer piece?
Sobuj bought three pieces of material. The first piece is 1 yard 2 feet 6 inches long, the second piece is 2 yards 1 feet 5 inches long, and the third piece is 4 yards 2 feet 7 inches long. If the cost of the material is Tk. 36 per yard, how much did Sobuj spent?
In a simple on-off controller with differential gap, the magnitude of differential gap determines
Pressure difference between two points in vessels, pipelines or in two different pipelines can be measured by a differential manometer. The pressure difference measured as the mm of water coloumn in case of mercury-water, differential manometer is equal to (where, H = difference in height of mercury column in mm).
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?