Related Questions

A company's profits have doubled for each of the last 5 years . If the total profits for the last 5 years were TK. 62 million , what were the profits in the first year ?
A 1
B 2
C 4
D 5
Which technique is used in finding a solution for optimizing a given objective, such as profit maximization or cost minimization under certain constraints?
A Quailing Theory
B Waiting Line
C Both A and B
D Linear Programming
A theory which describes techniques of operating income maximization, facing with non-bottleneck and bottle neck operations is
A theory of contribution
B theory of constraints
C theory of conflicts
D theory of maximization
As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint is the __________ joint.
A Butt
B Lap
C Welded
D None of these
A corporation that had Tk. 115.19 billion in profits for the year paid out Tk. 230.10 million in employee benefits . Approximately what percent of the profits were the employee benefits?
A 50%
B 0.2%
C 20%
D 5%
Three partners in a business shared a sum of TK. 1800/- in profits.What is the share of each if profits are shared in the ratio of 6:5:1 ?
A TK. 1100, TK. 500, TK. 200
B TK. 900, Tk. 800, TK.100
C TK. 900, TK. 750, TK. 150
D TK. 850, TK. 750, TK. 200
Percent contributed to profits by each of the 6 divisions, p through U, of company Y for the year 2000 and 2001 . Division R contributed how much less to the profits of company Y in 2001 than in 2000?
A Tk. 6000.00
B Tk.3000.00
C Tk. 180,000
D Tk. 100, 00
In terms of Oligopoly, which statement is correct?
A In an oligopoly, there is only one firm that makes up an industry.
B In an oligopoly, there are two firms that makes up an industry.
C In an oligopoly, there is only a few that make up an industry.
D In an oligopoly, there is on firm that makes up an industry.
Oligopoly exists when there is/are:
A Few sellers and few buyers
B Few sellers and many buyers
C Many sellers and few buyers
D One seller and few buyers
Welded joint is superior to revetted joint in respect of ease of fabrication, weight and strength. Which of the following joints is the most suitable for pipes carrying fluids under high pressure and temperature?
A Flanged joint
B Expansion joint
C Bell and spigot joint
D None of these

Next steps