Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is true when describing a unique local address?

Which of the following is true when describing a unique local address? Correct Answer These addresses are meant for nonrouting purposes, but they are almost globally unique so it is unlikely they will have an address overlap.

These addresses are meant for nonrouting purposes like link-local, but they are almost globally unique so it is unlikely they will have an address overlap. Unique local addresses were designed as a replacement for site-local addresses.

Related Questions

Engines are rated at specified conditions. Then which of the following statements are correct? 1. Power developed increases as local temperature increases. 2. Power developed increases as local temperature decreases 3. Power developed is not dependent on local temperature. 4. Power developed increases as local atmospheric pressure increases. 5. Power developed increases as local atmospheric pressure decreases.
Which of the following statements is/are correct? 1. An address generated by the CPU is commonly referred to as a physical address. 2. An address seen by the memory unit is commonly referred to as a logical address. 3. The run-time mapping from virtual to physical address is done by the memory management unit (MMU). Select the correct answer using the code given below.
Which two statements describe the IP address 10.16.3.65/23?
1. The subnet address is 10.16.3.0 255.255.254.0.
2. The lowest host address in the subnet is 10.16.2.1 255.255.254.0.
3. The last valid host address in the subnet is 10.16.2.254 255.255.254.0.
4. The broadcast address of the subnet is 10.16.3.255 255.255.254.0.
Which statement(s) about IPv4 and IPv6 addresses are true?1. An IPv6 address is 32 bits long, represented in hexidecimal.2. An IPv6 address is 128 bits long, represented in decimal.3. An IPv4 address is 32 bits long, represented in decimal.4. An IPv6 address is 128 bits long, represented in hexidecimal.
Which of the following is true when describing a link-local address?
Two statements are given followed by two conclusions I and II. You have to consider these statements to be true, even if they seem to be at variance with commonly known facts and choose which f the given conclusions logically follow(s) from the given statements. Statements : All Chairs are expensive All expensive are unique. Conclusion : I. All chairs are unique. II. All unique are expensive.
Let G be any connected, weighted, undirected graph. I. G has a unique minimum spanning tree, if no two edges of G have the same weight. II. G has a unique minimum spanning tree, if, for every cut of G, there is a unique minimum-weight edge crossing the cut. Which of the above two statements is/are TRUE?
Consider the following two statements. S1 : Destination MAC address of an ARP reply is a broadcast address. S2 : Destination MAC address of an ARP request is a broadcast address. Which one of the following choices is correct?
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
Which fields are contained within an IEEE Ethernet frame header?
1. Source and destination MAC address
2. Source and destination network address
3. Source and destination MAC address and source and destination network address
4. FCS field