Related Questions

Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.
A Acrylic
B Polyester
C Nylon 6:6
D Polypropylene
Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air.
A 50-80
B 250-400
C 1000-1200
D 800-900
The most stable allotropic form of phosphorous is the __________ phosphorous.
A White
B Black
C Yellow
D Red
Red phosphorous is changed into white phosphorous by
A Heating in presence of light
B Melting under pressure
C Vaporisation followed by condensation
D None of these
Both white phosphorous as well as red phosphorous
A Are soluble in CS2
B Burns when heated in air
C Reacts with hot caustic soda solution to give phosphine
D All of the above
If 2 kg of metal, of which 1/3 is zine and the rest is copper , be mixed with 3 kg of metal, of which 1/4 is zinc and the rest is copper , then what will be the ratio of zinc to copper in the mixture?
A 17 : 43
B 13 : 42
C 19 : 43
D 15 : 42
If 2 kg of metal, of which 1/3 is zinc and the rest is copper s, be mixed with 3 kg of metal , of which 1/4 is zinc and the rest is copper , then what will be the ratio of zinc to copper in the mixture?
A 13 : 42
B 19 : 43
C 15 : 42
D 17 : 43
The molecular formula of phosphorous is
A P1
B P2
C P3
D P4
Most of the phosphorous present in the blast furnace burden enters into
A Hot metal
B Flue gases
C Slag
D Refractory lining
Yield of elemental phosphorous from rock phosphate is about __________ percent.
A 1-2
B 15-25
C 40-45
D 60-65

Next steps