Match the heat treatment process in Group Iwith resultant microstructure Group II.

Match the heat treatment process in Group Iwith resultant microstructure Group II.
Correct Answer P-3, Q-2, R-4, S-1

Bissoy MCQ

Related Questions

Match the heat treatment for an eutectoid steel shown in the TTT diagram below (as P, Q, R and S) with the resulting microstructure listed below:
1. Fine pearlite
2. martensite
3. Bainite
4. Coarse pearlite
Physical Metallurgy mcq question image
Match the materials in Group 1 with the possible microstructure adjacent to the fusion line in the heat affected zone, in Group 2.
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow and k = Thermal conductivity of the body)
Match the heat treatment processes of steel in Group 1 with the microstructural features in Group 2.
Heat treatment involves heating of the sludge. The supernatant from the heat treatment system is rich in ___________
Statement 1: Destruction of the phosphate based enzyme in milk after heat treatment is an indication that several pathogens have been destroyed. Statement 2: Destruction of the peroxide based enzyme in fruits after heat treatment is an indication that several pathogens have been destroyed.
A material that requires __________ heat-treatment is preferred over a material that requires a ___ of heat-treatment.
A cold fluid (specific heat 2.95 k J/kg K) at 10 kg/min is to be heated from 25 degree Celsius to 55 degree Celsius in a heat exchanger. The task is accomplished by extracting heat from hot water (specific heat 4.186 k J /kg K) available at mass flow rate 5 kg/min and inlet temperature 85 degree Celsius. Identify the type of arrangement of the heat exchanger
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the effectiveness of the heat exchanger. At the condensing pressure, stream has a saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to the water. Take specific heat of water as 4 k J/kg K