Related Questions

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.
A Once
B Twice
C Thrice
D Four times
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
A Decreases the pressure drop
B Decreases the outlet temperature of cooling medium
C Increases the overall heat transfer coefficient
D None of these
In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is
A Infinity
B Zero
C Same as average heat transfer co-efficient for tube side
D None of these
In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.
A Increases
B Decreases
C Does not affect
D May increase or decrease, depends on the type of baffle
In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.
A 3-5
B 5-11
C 8-15
D 12-18
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
A $$\frac{{4\left( {{{\text{p}}^2} - \pi {{\text{d}}^2}/4} \right)}}{{\pi {\text{d}}}}$$
B $$\frac{{{{\text{p}}^2} - \pi {{\text{d}}^2}/4}}{{\pi {\text{d}}}}$$
C $$\frac{{4{{\text{p}}^2}}}{{\pi {\text{d}}}}$$
D $$\frac{{\pi {\text{d}}}}{{4{{\text{p}}^2}}}$$
A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires
A Less heating surface
B More space
C Lower maintenance cost
D None of these
Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle?
A Segmental baffle
B Flat plate extending across the wall
C Disk type baffle
D Helical type baffle
In a shell and tube heat exchanger, the shell side fluid velocity can not be changed by changing the
A Tube layout
B Tube diameter
C Tube pitch
D No. of baffles

Next steps