Related Questions

While the thermosetting polymers are amorphous in nature, the thermoplastic polymers are either amorphous or crystalline. The crystalline polymers are characterised by the
A Low impact strength
B High flexibility
C Better finish and surface appearance
D High plastic deformation
Thermosetting resins/polymers as compared to thermoplastic ones are
A Soluble in all organic solvents
B More brittle
C Formed by addition polymerisation only
D Easily reshaped & reused
Thermosetting resins are those polymers, which
A Do not increase in plasticity with rise in temperature
B Allow slip to occur between molecules
C Do not take on a permanent set
D None of these
Thermoplastic resins are those polymers, which
A Has decreased plasticity at increasing temperature
B Can not be moulded
C Easily deform under pressure at high temperature
D None of these
Thermosetting polymers as compared to thermoplastic polymers
A Are formed by addition polymerisation
B Have three dimensional structure
C Have linear structure
D None of these
Branched chair polymers as compared to linear polymers have
A Higher melting point
B Higher tensile strength
C Lower density
D None of these
In a linear polymer, the monomeric units are linked together to form long straight chains. The cross linked or branched chain polymers compared to linear polymers have higher
A Densities
B Melting point
C Tensile strength
D Hardness, rigidity & brittleness
Branched chain polymers compared to linear polymers have higher
A Density
B Tensile strength
C Melting point
D Degree of irregularity in atomic packing
Epoxy resin is
A Not used for surface coating
B A good abrasive
C An elastomer
D A polyester
Epoxy resin
A Is a good adhesive
B Is an elastomer
C Cannot be used for surface coatings
D Is a polyester

Next steps