Related Questions

Introduction of slurry in a plate and frame filter press is done through a plate in each frame. The plate of this filter has a __________ surface.
A Plane
B Curved
C Ribbed
D Either A or B
The ratio for the rate of washing to the final rate of filtration in a washing type of plate and frame filter is
A 0.25
B 0.50
C 0.75
D 1.25
In case of a plate and frame filter press, filtrate flow through the cake follows __________ flow.
A Plug
B Turbulent
C Laminar
D None of these
Flow of filtrate through the cake in a plate and frame filter press is best described by the __________ equation.
A Kozney-Karman
B Hagen-Poiseulle's
C Fanning's
D Kremser
Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
A 0.25 to 4
B 0.25 to 8
C 1 to 5
D 1 to 12
A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for __________ flow of filtrate.
A Compressible cakes and laminar
B Incompressible cake and laminar
C Compressible cake and turbulent
D Incompressible cake and turbulent
The cost of picture frame M is Tk. 10.00 less than 3 times the cost of picture frame N. If the cost of frame M is Tk. 50.00, what is the cost of frame N?
A Tk. 13.33
B Tk. 16.66
C Tk. 20.00
D Tk. 26.66
The cost of picture frame M is TK. 10.00 less than 3 times the cost of picture frame N. If the cost of frame M is TK. 50.00 , what is the cost of frame N?
A TK. 13.33
B TK. 16.66
C TK. 20.00
D TK. 26.66
Plate and frame filter press is usually made of
A Mild steel
B Cast iron
C Stainless steel
D Galvanised iron
Thickness of the frame of a plate and frame filter as compared to that of plates is
A Less
B Same
C More
D Either A or B

Next steps