Related Questions

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
During agitation of liquids, power consumption during laminar flow is not proportional to the
The approximate liquid depth in an agitation tank is equal to (where, d = tank diameter)
A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:
Two tanks are filled to capacity with automobile fuel. The first tank holds 600 gallons more than the second tank. If 100 gallons were to be pumped from each tank, the first tank would then contain 3 times as much fuel as the second tank. What is the total number of gallons of fuel in the two full tanks?
A tank is fitted with 8 pipes, some of them that fill the tank and others that are waste pipe meant to those that empty the tank can empty it in 6 hours. If all the pipes are kept open when the tank is full, it will take exactly 6 hours for the tank to empty. How many of these are these are fill pipes?
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank?
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank ?
Tube side heat transfer co-efficient for turbulent flow of liquid through tubes is proportional to
For turbulent flow of an incompressible fluid through a pipe, the flow rate Q is proportional to (Δ P)n, where ΔP is the pressure drop. The value of exponent 'n' is