Related Questions

Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C.
Furnace oil consumption in a furnace for a given duty employing preheated combination air (at 300° ) may be reduced by about __________ percent as compared to the use of atmospheric combustion air.
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:
Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace?
What is minimum amount of air required per m3 of gaseous fuel for complete combustion? m3/m3 of fuel b) 1/100 m3/m3 of fuel c) 1/21 m3/m3 of fuel d) 1/100 m3/m3 of fuel
With reference to 'fuel cells' in which hydrogen rich fuel and oxygen are used to generate electricity. Consider the following statements.
1. If pure hydrogen is used as a fuel, the fuel cell emits heat and water as by products.
2. Fuel cells can be used for powering buildings and not for small devices like laptop, computers.
3. Fuel cells produce electricity in the form of Alternating Current (AC).
Which of the statements given above is/are correct?
Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
Major sources of noise in furnace operation arises from air inspirators, combustion, side wall vibrations and fluctuation in the process heat load. A 50% increase in fuel firing rate may increase the furnace noise level by about __________ decibels.
Which of the following is not increased by using preheated combustion air in place of ordinary air at room temperature?
Advantages of use of preheated combustion air are