Related Questions

The process used to improve fatigue resistance of the metal by setting up compressive stresses in its surface, is known as
A Hot piercing
B Extrusion
C Cold peening
D Cold heading
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
A 0.5
B 1
C 1.5
D 2
Endurance is a measure of fatigue limit of a metal. Fatigue crack in nitrided machine parts originates
A At the surface
B Within the core
C Just below the surface
D Anywhere on the surface
Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails
A Below the yield point
B Above the yield point
C Below the elastic limit
D At the elastic limit
The compressive strength of cast iron is __________ that of its tensile strength.
A Equal to
B Less than
C More than
D None of these
The tensile strength of ductile materials is _________ its compressive strength.
A Equal to
B Less than
C Greater than
D None of these
Compressive strength of wood is usually more along the grains. The tenile strength of wood as compared to that of steel is about
A Half
B One third
C One fifth
D One twelfth
ভঙ্গুর পদার্থের compressive strength, tensile strength হতে -
A বেশি
B কম
C সমান
D দ্বিগুণ
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)
A $$\frac{{{\text{P}}l{\text{A}}}}{{\text{E}}}$$
B $$\frac{{{\text{P}}l}}{{{\text{AE}}}}$$
C $$\frac{{\text{E}}}{{{\text{P}}l{\text{A}}}}$$
D $$\frac{{{\text{AE}}}}{{{\text{P}}l}}$$

Next steps