Related Questions

The response curve for a step input signal from a reactor is called C-curve. The variance of C-curve in a 'tanks in series model' comprising of 'm' tanks is equal to
A m
B $$\frac{1}{{\text{m}}}$$
C $$\sqrt {\text{m}} $$
D m2
Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele's method, this method
A Is more accurate in finding the number of equilibrium stages
B Accounts for the enthalpy changes in the process
C Facilitates direct calculation of heat load on reboiler & condenser from, the diagram used in this method
D All of the above
If the gain versus frequency curve of a transistor amplifier is not flat, then there is distortion.
A Amplitude
B Intermodulation
C Frequency
D None of the above
A class A power amplifier is sometimes called ___________ amplifier
A Symmetrical
B Single-ended
C Reciprocating
D Differential
The bandwidth of a single stage amplifier is ___________ that of a multistage amplifier
A More than
B The same as
C Less than
D Data insufficient
A control system is unstable, if the open loop frequency response exhibits an amplitude ratio exceeding unity at the crossover frequency. This is __________ criterion.
A Bode stability
B Nyquist
C Routh stability
D None of these
According to Bode stability criterian, a system is unstable, if the open loop frequency response exhibits an amplitude ratio exceeding unity at frequency for which phase lag is
A 0°
B 45°
C 90°
D 180°
In an RC coupled amplifier, the voltage gain over mid-frequency range ___________
A Changes abruptly with frequency
B Is constant
C Changes uniformly with frequency
D None of the above
The voltage gain of a tuned amplifier is ___________ at resonant frequency
A Minimum
B Maximum
C Half-way between maximum and minimum
D Zero
The frequency generated by each decade in a direct frequency synthesizer is much higher than the frequency shown; this is done to
A Reduce the spurious frequency problem
B Increase the frequency stability of the synthesizer
C Reduce the number of decades
D Reduce the number of crystals required

Next steps