Related Questions

After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
Wages of the workers are normally, the proportionality derived from their efficiency. But the concept of efficiency of labour is itself vague such as amount of physical output, output per man hour or output per man shift. But output is not the function of man alone. There are other factors which affect the output. Which among the following is/are not the factor(s) that would affect the output directly?
1. Physical condition of work
2. Nature of machinery
3. Technical process
4. Quality of raw material
5. System of management
6. Role of fellow workers
7. Competitors in the market
Two single phase transformers A and B are operating in parallel having different impedance and identical x/r ratio. Impedance of A is Za and impedance of B is Zb, both sharing a load of Sl. Then the load shared by transformer A is?
Two single phase transformers A and B are operating in parallel having different impedance and identical x/r ratio. Impedance of A is Za and impedance of B is Zb, both sharing a load of Sl. Then the load shared by transformer B is?
The primary impedance of a transformer is 60 ohm and the secondary impedance is 120 ohm. What is the impedance ratio?
An amplifier has a noise equivalent temperature of 170 K. If the amplifier is used with a source having an equivalent noise temperature of TS=450 K, the output noise power of the amplifier is:
If the output power of an amplifier is 10 V, and the input power supplied to the amplifier is 0.229 V given that the DC voltage used is 38.5 V, efficiency of the power amplifier is:
An amplifier of gain 1000 is made into a feedback amplifier by feeding 9.9% of its output voltage in series with the input opposing. If fL = 20 Hz and fH = 200 kHz for the amplifier without feedback, then due to the feedback
An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ & Output resistance of 2.5 kΩ.The input resistance of the current shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is
If the output impedance of the current source is Ri, what is the output impedance of the CS stage shown below, if channel length modulation is neglected?