Related Questions

Which of these statements are correct?
1. Ocean currents are the slow- surface movement of water in the ocean.
2. Ocean currents assist in maintaining the Earth's heat balance.
3. Ocean currents are set in motion primarily by prevailing winds.
4. Ocean currents are affected by the configuration of the ocean.
In case of three-phase dual converter, one of the converter circuits is fired at an angle of 60°. For both the converter circuits to have equal average output voltage, what is the value of the firing angle for the other converter circuit?
Which of the following option is true about rotary tables? Statement 1: Index is not used with optical rotary table. Statement 2: Accurate worm and gear rotary table can be used with an index plate.
Which of these statements are correct?
1. Ocean currents are the slow-surface movement of water in the ocean
2. Ocean currents assist in maintaining the Earth's heat balance
3. Ocean currents are set in motion primarily by prevailing winds
4. Ocean current are affected by the configuration of the ocean
Which of the following are reasons for the chief fishing grounds being located in continental shelf areas where cold and warm currents meet?
I. Warm currents are rich in phosphates and nitrates
II. Plankton - the chief fish feed - thrives in these regions
III. The meeting of cold and warm currents allows the water to be well aerated
IV. The epicontinental seas allow sunlight to reach almost to the bottom
Assertion (A): Slotted armature type in this armature is placed in slotted armature with DC windings placed inside the slots. Reason (R): The construction is highly reliable and rugged but has high torque.
A 4-pole wave wound DC motor drawing an armature current of 20 A has provided with 360 armature conductors. If the flux per pole is 0.015 Wb then the torque developed by the armature of motor is _______
The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be
A single phase full-converter using R load is a _________ quadrant converter and that using an RL load without FD is a __________ quadrant converter
In a three phase dual converter, converter 1 is operating with α = 95° and converter 2 is operating with α2 = 85°. Choose the correct statement.