Related Questions

If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
A ARC
B Short ARC
C ARC length
D ARC blow
In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as
A Fusion
B Reverse polarity
C Forward welding
D Direct polarity
The length of an arc is 7π. If the diameter of the circle is 14, what is the degree of central angle by that arc?
A 90°
B 120°
C 180°
D 270°
It is desirable to operate the arc furnaces at power factor of
A Zero
B 0.707 lagging
C Unity
D 0.707 leading
In arc welding, the electric arc is produced between the work and the electrode by
A Voltage
B Flow of current
C Contact resistance
D All of these
In mercury arc rectifiers having grid, the arc can be struck between anode and cathode only when the grid attains a certain potential, this potential being known as
A maximum grid voltage
B critical grid voltage
C any of the above
D none of the above
The potential drop in the arc, in a mercury arc rectifier, varies
A 0.05 V to 0.2 V per cm length of the arc
B 0.5 V to 1.5 V per cm length of the arc
C 2 V to 3.5 V per cm length of the arc
D none of the above
In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position.
A Globular transfer
B Spray transfer
C GMAW practice
D Dip transfer
In submerged arc welding, an arc is produced between a
A Carbon electrode and the work
B Metal electrode and the work
C Bare metal electrode and the work
D Two tungsten electrodes and the work
In arc welding, the temperature of heat produced by the electric arc is of the order of
A 3000°C to 4000°C
B 4000°C to 5000°C
C 5000°C to 6000°C
D 6000°C to 7000°C

Next steps