Related Questions

In heating the ferromagnetic material by induction heating, heat is produced due to
A Induced current flow through the charge
B Hysteresis loss taking place below Curie temperature
C Due to hysteresis loss as well as eddy current loss taking place in the charge
D None of the above factors
Heating wet steam at constant temperature is heating it at constant
A Volume
B Pressure
C Entropy
D Enthalpy
In a regenerative feed heating cycle, the optimum value of the fraction of steam extracted for feed heating
A Decreases with increase in Rankine cycle efficiency
B Increases with increase in Rankine cycle efficiency
C Is unaffected by increase in Rankine cycle efficiency
D None of the above
In resistance heating highest working temperature is obtained from heating elements made of
A Nickel copper
B Nichrome
C Silicon carbide
D Silver
In an electric room heat convector the method of heating used is Resistance heating
A True
B False
Gross heating value of coal is __________ the net heating value.
A Higher than
B Lower than
C Same as
D None of these
An alloy used in making heating elements for electric heating device is
A Solder
B Alloy Steel
C Nichrome
D German Silver
Induction heating takes place in which of the following?
A Insulating materials
B Conducting materials which are magnetic
C Conducting materials which are nonmagnetic
D Conducting materials which may or may not be magnetic
Induction heating takes place it which of the following?
A Insulating materials
B Conducting materials which are magnetic
C Conducting materials which are non-magnetic
D Conducting materials which may or may not be magnetic
In induction heating __________ is abnormally high.
A Phase angle
B Frequency
C Current
D Voltage

Next steps