Related Questions

In an unregulated power supply, if load current increases, the output voltage ___________
If the load current drawn by unregulated power supply increases, the d.c. output voltage ___________
A power supply which has voltage regulation of ___________ is unregulated power supply
What are the conditions to be satisfied by a voltage source for using it in switching regulator. i. It must supply the required output power and the losses associated with the switching regulator ii. It must be large enough to supply sufficient dynamic range line and load variations iii. It must be sufficient high to meet the minimum requirement of the regulator system to be designed iv. It may be required to store energy for a specified amount of time during power failure especially if the system is designed for a computer power supply.
A sinusoidal input voltage Vin of frequency ω is fed to the circuit shown in the figure, where C1 ≫ C2. If Vm is the peak value of the input voltage, then output voltage (Vout) is
Electronics mcq question image
If the input a.c. voltage to regulated or ordinary power supply increases by 5% what will be the approximate change in d.c. output voltage?
A word arrangement machine, When given an input line of words, rearranges it in every step following a certain rule. Following is an illustration of an input line of words and various steps of rearrangement.
Input: gone are take enough brought station
Step 1: take gone are enough brought station
Step 2: take are gone enough brought station
Step 3: take are station gone enough brought
Step 4: take are station brought gone enough
And Step 4 is the last step for this input. Now, find out an appropriate step in the following question following the above rule. Question:
Input: car on star quick demand fat
What will be the third step for this input ?
A 3-input neuron is trained to output a zero when the input is 110 and a one when the input is 111. After generalization, the output will be zero when and only when the input is?
In a circuit the load current is 5 mA and the unregulated output is 10 V. If the voltage drop across the Zener diode is 3 V, what should be the value of resistance?
In which test the power of supply unit is kept switched off and the resistance at the divergent point is measured in power supply unit in troubleshooting of power supply unit?