Related Questions

Which of the following is an advantage of static capacitor for power factor improvement ?
A Little maintenance cost
B Ease in installation
C Low losses
D All of the above
While testing a capacitor with ohm meter, if the capacitor shows charging, but the final resistance reading is appreciably less than normal, it can be concluded that the capacitor is
A Short-circuited
B Open circuited
C Alright
D Leaky
A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
A remain same
B go down
C improve
D none of the above
A capacitor in a circuit became hot and ultimately exploded due to wrong connections, which type of capacitor it could be ?
A Paper capacitor
B Ceramic capacitor
C Electrolytic capacitor
D Any-of the above
A mica capacitor and a ceramic capacitor both have the same physical dimensions. Which will have more value of capacitance ?
A Ceramic capacitor
B Mica capacitor
C Both will have identical value of capacitance
D It depends on applied voltage
In a two value capacitor motor, the capacitor used for running purposes is
A air capacitor
B paper spaced oil filled type
C ceramic type
D a.c. electrolytic type
When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is
A Short-circuited
B All right
C Faulty
D None of the above
In a capacitor start single-phase motor, when capacitor is replaced by a resistance
A torque will increase
B the motor will consume less power
C motor will run in reverse direction
D motor will continue to run in same direction
In a capacitor start and run motors the function of the running capacitor in series with the auxiliary winding is to
A improve power factor
B increase overload capacity
C reduce fluctuations in torque
D to improve torque
The input capacitor in an amplifier is the ___________ capacitor
A Coupling
B Bypass
C Leakage
D None of the above

Next steps