If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then

If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then Correct Answer electrolytic capacitor will, in all probability, suffer break down

Bissoy MCQ

Related Questions

You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation which of these capacitor should have minimum value?
Two capacitors having capacitance value 4F, three capacitors having capacitance value 2F and 5 capacitors having capacitance value 1F are connected in parallel, calculate the equivalent capacitance.
Which of the following types of connections can use full duplex?
1. Hub to hub
2. Switch to switch
3. Host to host
4. Switch to hub
5. Switch to host
An uncharged capacitor and a 1 kΩ resistor are connected in series with a switch and a 6 V battery. At the instant the switch is closed, the voltage across the capacitor is
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation of clapp oscillator value of C3 should be __________
A centrifugal pump which circulates a hot liquid metal at 500 degree Celsius is driven by a 3600 rpm electric motor. The motor is coupled to the pump impeller by a horizontal steel shaft of dia 25 mm. Let us assume the motor temperature as 60 degree Celsius with the ambient air at 25 degree Celsius, what length of shaft should be specified between the motor and the pump? It may be presumed that the thermal conductivity of the shaft material is 35W/m K and that the convective film coefficient between the steel shaft and the ambient air is 15.7W/square m K
A diode circuit is so arranged that when the switch is open it’s KVL gives Ri+ 1/C ∫i dt = 0 When the switch is closed, Ri+ 1/C ∫i dt = Vs Vs is the dc supply voltage. The diode is so connected that it is forward biased when switch is closed The circuit is mostly likely be a
Two series capacitors (one 2 µF, the other of unknown value) are charged from a 24 V source. The 2 µF capacitor is charged to 16 V and the other to 8 V. The value of the unknown capacitor is
In mid frequency region, the large capacitors are short and small capacitors are open circuited. What happens to the RC coupled circuit?