Related Questions

In triangle PQR length of the side QR is less than twice the length of the side PQ by 2 cm. Length of the side PR exceeds the length of the side PQ by 10 cm. The perimeter is 40 cm. the length of the smallest side of the triangle PQR is:
A 6 cm
B 8 cm
C 9 cm
D 10 cm
a motor -cycle covers 40 Km with a speed of 20 km /hr. Find the speed of the motor -cycle for the next 40 km journey so that the average speed of the whole journey will be 30 km / hr.
A 70.0km /hr
B 52.5km /hr
C 60.0km/hr
D 60. 5 km / hr
A motor cycle covers 40 km with a speed of 20 km/hr. Find the speed of the motor cycle for the next 40 km journy so that the average speed of the whole journey will be 30 km/hr?
A 70
B 52.5
C 60
D 60.5
A wound rotor induction motor is preferred, as compared to squirrel cage induction motor, when major consideration is
A Slop speed operation
B High starting torque
C Low windage losses
D All of the above
When the stator windings are connected in such a fashion that the number of poles are made half, the speed of the rotor of a synchronous motor
A remains same as the original value
B decreases to half the original value
C tends to becomes zero
D increases to two times the original value
What will happen if the relative speed between the rotating flux of stator and rotor of the induction motor is zero?
A The slip of the motor will be 5%
B The rotor will not run
C The rotor will run at very high speed
D The torque produced will be very large
A 4 pole 50 Hz induction motor is running at 1300 rpm. Find the speed of stator magnetic field with respect to the rotor?
A 200 rpm
B 1500 rpm
C 1300 rpm
D 1700 rpm
By looking at which part of the motor, it can be easily confirmed that a particular motor is D.C. motor?
A Frame
B Shaft
C Commutator
D Stator
Size of a high speed motor as compared to low speed motor for the same H.P. will be
A Bigger
B Smaller
C Same
D Any of the above
The speed of a squirrel-cage induction motor can be controlled by all of the following except
A Changing supply frequency
B Changing number of poles
C Changing winding resistance
D Reducing supply voltage

Next steps