Related Questions

3/4th of square were taken to form shape A and the rest was made to form shape B. Shape A was divided into four equal squares (Shape C), what will be the ratio of the one shape C to one shape B.
A 1:4
B 3:16
C 1:2
D 3:4
A wound rotor induction motor is preferred, as compared to squirrel cage induction motor, when major consideration is
A Slop speed operation
B High starting torque
C Low windage losses
D All of the above
Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele's method, this method
A Is more accurate in finding the number of equilibrium stages
B Accounts for the enthalpy changes in the process
C Facilitates direct calculation of heat load on reboiler & condenser from, the diagram used in this method
D All of the above
While starting a synchronous motor by induction motor action, field winding is usually
A connected to D.C. supply
B short-circuited by low resistance
C kept open-circuited
D none of the above
A synchronous motor has better power factor as compared to that of an equivalent induction motor. This is mainly because
A synchronous motor has no slip
B stator supply is not required to produce magnetic field
C mechanical load on the rotor remains constant
D synchronous motor has large airgap
While starting a salient pole synchronous motor by induction motor action and connecting field discharge resistance across field, starting and accelerting torque is produced by
A induction motor torque in field winding
B induction motor torque in damper winding
C eddy current and hysteresis torque in pole faces
D reHetance motor torque due to saliency of the rotor
E all of the above methods
Slip ring motor is preferred over squirrel cage induction motor where
A High starting torque is required
B Load torque is heavy
C Heavy pull out torque is required
D All of the above
The power factor of a synchronous motor is better than that of induction motor because
A stator supply is relieved of responsibility of producing magnetic field
B mechanical load on the motor can be adjusted
C synchronous motor runs at synchronous speed
D synchronous motor has large air gap
An important advantage of a synchronous motor over wound round induction motor is that
A its power factor may be varied at will
B its speed is independent of supply frequency
C its speed may be controlled more easily
D none of the above
The response curve for a step input signal from a reactor is called C-curve. The variance of C-curve in a 'tanks in series model' comprising of 'm' tanks is equal to
A m
B $$\frac{1}{{\text{m}}}$$
C $$\sqrt {\text{m}} $$
D m2

Next steps