Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In case of synchronous motor, which of the following are true? a. Synchronous motor is not self-starting b. If the rotor poles are excited by field current and the stator terminals are connected to AC supply, motor vibrates. c. Variable frequency supply is used to start synchronous motor. d. By using frequency converter, a synchronous motor can be brought from standstill to its desired speed.
Consider the following statements regarding synchronous machines: 1. When a synchronous motor is over-excited, its back emf is greater than the supply voltage 2. When a synchronous motor is over-excited, its power factor is leading 3. Synchronous motor is used as capacitor where load is so large that construction of a static capacitor is impractical Which of these statements are correct?
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
Which of the following statements are correct for synchronous motors? 1. Synchronous motors are well-suited for direct connection top reciprocating compressors. 2. Over-excited synchronous motors are most commonly used for power factor improvement. 3. Synchronous motors are generally used for current regulation of long transmission lines Select the correct answer using the code given below.
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
During the short-circuit test of a synchronous machine, which of the following are accounted for in the short-circuit test loss? (i), I2R loss in the armature winding due to the flow of short-circuiting (AC) current (ii) Local core loss caused by armature leakage flux (iii) Core loss due to resultant air-gap flux. (iv) Windage and friction loss
A synchronous motor absorbing 60 kW is connected in parallel with an continuous load of 240 kW operating at 0.8 power factor lag.What is the kVAR supplied by the synchronous motor to obtain a total power factor of 0.9 lagging?
A synchronous motor is running on a load with normal excitation. Now if the load on the motor is increased
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?