Related Questions

A machine started malfunctioning due to some issues with the coupling. The coupling emplaced in the machine was Oldham. The only coupling available in the workshop is Hooke’s coupling. So Oldham coupling can be replaced by Hooke’s coupling.
The coupling angle or load angle of a synchronous motor is defined as the space angle between __________
A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
In a two-electron atomic system having orbital and spin angular momenta $${l_1}{l_2}$$  and $${s_1}{s_2}$$  respectively, the coupling strengths are defined as $${\Gamma _{{l_1}{l_2}}},\,{\Gamma _{{s_1}{s_2}}},\,{\Gamma _{{l_1}{s_1}}},\,{\Gamma _{{l_2}{s_2}}},\,{\Gamma _{{l_1}{l_2}}}$$      and $${\Gamma _{{l_2}{s_1}}}.$$  For the jj coupling. scheme to be applicable, the coupling strengths must satisfy the condition
A synchronous motor absorbing 60 kW is connected in parallel with an continuous load of 240 kW operating at 0.8 power factor lag.What is the kVAR supplied by the synchronous motor to obtain a total power factor of 0.9 lagging?
A synchronous motor is running on a load with normal excitation. Now if the load on the motor is increased
A synchronous motor is operated at a bus voltage of 1.5 pu and drawing 1.0 pu at zpf leading current. Its synchronous reactance is 0.4 pu. What is the excitation emf of the motor?
For the below graph depicting the performance of a synchronous motor, coordinates ‘x’ and ‘y’ are respectively? In the ‘V’ curve shown in the above figure for a synchronous motor, the parameter of x and y coordinates are, respectively.
The maximum power developed in a synchronous motor occurs at a coupling angle of
A centrifugal pump which circulates a hot liquid metal at 500 degree Celsius is driven by a 3600 rpm electric motor. The motor is coupled to the pump impeller by a horizontal steel shaft of dia 25 mm. Let us assume the motor temperature as 60 degree Celsius with the ambient air at 25 degree Celsius, what length of shaft should be specified between the motor and the pump? It may be presumed that the thermal conductivity of the shaft material is 35W/m K and that the convective film coefficient between the steel shaft and the ambient air is 15.7W/square m K