Related Questions

Charging a sulphated battery at high rate results in
A boiling of electrolyte due to gassing
B warping of plates
C damage to separators, cell caps covers and battery case due to excessive temperature
D all above
K produces 100 parts twice as fast as G does. G produces 100 parts in 40 minutes. If each produces parts at a constant rate, how many parts will K produces in 6 minutes.
A 30
B 25
C 20
D 15
Sulphated cells are indicated by
A the loss of capacity of the cell
B the decrease of the specific gravity
C the low voltage of the cell on discharge
D all above conditions
In a battery cover is placed over the element and sealed to the top of the battery container. This is done
A to reduce evaporation of water from electrolyte
B to exclude dirt and foreign matter from the electrolyte
C to discharge both of the above functions
D to discharge none of the above functions
The battery is an electrochemical device, which means battery
A Makes chemicals by mechanical means
B Uses chemical action to provide electricity
C Has curved plates instead of flat plates
D Does not use an electrolyte
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
Machine A produces bolts at a uniform rate of 120 every 40 seconds and Machine B produces bolts at a uniform rate of 100 every 20 seconds. If the two machines run simultaneously , how many seconds will it take for them to produce a total of 200 bolts.
A 22
B 25
C 28
D 32

Next steps