Related Questions

Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?
Consider the following statements with reference to the response of a control system: 1. A large resonant peak corresponds to a small overshoot in transient response. 2. A large bandwidth corresponds to slow response. 3. The cut-off rate indicates the ability of the system to distinguish the signal from noise 4. Resonant frequency is indicative of the speed of transient response. Which of the above statements are correct?
Assertion (A): All the systems which exhibit overshoot in transient response will also exhibit resonance peak in frequency response. Reason (R): Large resonance peak in frequency response corresponds to a large overshoot in transient response.
In a power system, which of the following is/are critical clearance time of a fault related to? 1. Transient reactance 2. Sub-transient reactance 3. Reactive power limit 4. Transient stability limit
Which of the following is the best method for determining the stability and transient response?
Below are given two sets, Set - I which gives modalities of operant conditioning and Set - II which provides the types of reinforcement, the types of responses (responses made or withheld) and the presence or absence of cue. Match the two sets and indicate your answer by choosing from the code : Set - I (Modalities of operant conditioning procedures) Set – II           (Conditions and contexts) (a) Reward training (i) Positive reinforcement, response made, with cue present (b) Escape training (ii) Positive reinforcement, response withheld with cue absent (c) Discriminated omission training   (iii) Positive reinforcement, response made with cue absent (d) Active avoidance   (iv) Negative reinforcement, response made with training (e) Punishment training (v) Positive reinforcement, response withheld with cue present   (vi) Negative reinforcement, response withheld with cue absent  
Assertion (A): It is desirable that the transient response be sufficiently fast and sufficiently damped. Reason (R): Oscillations are not tolerated in the transient response.
(i) Transient stability is lower than SSSL. (ii) Transient disturbances are more common.
The transient stability and the steady state stability of a power transmission system ________
Which of the following methods is the strongest tool to determine the stability and the transient response of the system?