Related Questions

A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
The horizontal plates of a CRO are supplied with ___________ to observe the waveform of signal.
A Sinusoidal wave
B Cosine wave
C Sawtooth wave
D None of the above
In leaf springs, the maximum bending stress developed in the plates is (where W = Load acting on the spring, $$l$$ = Span of the spring, n = Number of plates, b = Width of plates and t = Thickness of plates)
A $$\frac{{{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
B $$\frac{{3{\text{W}}l}}{{2{\text{nb}}{{\text{t}}^2}}}$$
C $$\frac{{2{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
D $$\frac{{3{\text{W}}l}}{{{\text{nb}}{{\text{t}}^2}}}$$
The ratio of the length to the width of a rectangular advertising display is approximately 3.3 to 2. If the width of the display is 8 meters, what is the approximate length of the display, in meters?
A 7
B 11
C 13
D 16
A CRO can display
A AC signals
B DC signals
C Both AC and DC signals
D Time invariant signals
If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be
A 10 mm/m
B 16 mm/m
C 20 mm/m
D 26 mm/m
For given applied voltage, with the increase in frequency of the applied voltage
A eddy current loss will decrease
B eddy current loss will increase
C eddy current loss will remain unchanged
D none of the above
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as ________ double cover butt joint.
A Single riveted
B Double riveted
C Multi riveted
D None of these
When two plates are butt together and riveted with cover plates with two rows of rivets, the joint is known as
A Lap joint
B Butt joint
C Single riveted single cover butt joint
D Double riveted double cover butt joint
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint.
A Single riveted
B Double riveted
C Both (A) and (B)
D None of these

Next steps