Related Questions

When a transistor is driven to saturation, ideally the output is ___________.
A VCC
B 0
C $$\frac{{{{\text{V}}_{{\text{CC}}}}}}{2}$$
D 2VCC
A car averages 25 miles per gallon of gasoline when driven in the city and 40 miles per gallon when driven on the highway. According to these rates, which of the following is closest to the number of miles per gallon that the car averages when it is driven 10 miles in the city and then 50 miles on the highway?
A 64
B 36
C 12
D 29
A car averages 25 miles per gallon of gasoline when driven in the city and 40 miles per gallon when driven on the highway. According to these rates, which of the following is closest to the number of miles per gallon that the car average when it is driven 10 miles in the city and then 60 miles on the highway?
A 64
B 36
C 12
D 29
When a transistor is cut off or saturated, transistor _____ have almost no effect
A wave
B variations
C stage
D circuits
E None of the above
A tailor had a number of shirt pieces to cut from some large pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute . How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?
A 32 rolls
B 54 rolls
C 108 rolls
D 120 rolls
The value of collector load RC in a transistor amplifier is ___________ the output impedance of the transistor.
A The same as
B Less than
C More than
D None of the above
When the transistor (CE arrangement) is in the cut off region, the collector current is ___________.
A ICBO
B ICEO
C (ß + 1) ICEO
D IC(sat)
With zero volts on both inputs, an OP-amp ideally should have an output ___________
A equal to the positive supply voltage
B equal to the negative supply voltage
C equal to zero
D equal to CMRR

Next steps