Related Questions

In sheet metal blanking, shear is provided on punches and dies so that
A Press load is reduced
B Good cut edge is obtained
C Warping of sheet is minimized
D Cut blanks is straight
Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be
A Level compounded
B Under compounded
C Cumulatively compounded
D Differentially compounded
Of the 120 households in an area, 55 have cars, 35 have motor bikes, and 20 have both cars and motor bikes. How many of the households in the area have neither cares nor motor bikes?
A 110
B 90
C 50
D 30
One D.C. motor drives another D.C. motor. The second D.C. motor when excited and driven
A Runs as a generator
B Does not run as a generator
C Also runs as a motor comes to stop after sometime
D None of these
A motor pool has 300 vehicles of which 30% are trucks. 20% of all the vehicles in the motor pool are diesel, including 15 trucks. What percent of the motor pool is composed of vehicles that are neither trucks nor diesel?
A 165%
B 90%
C 65%
D 10%
By looking at which part of the motor, it can be easily confirmed that a particular motor is D.C. motor?
A Frame
B Shaft
C Commutator
D Stator
A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
A remain same
B go down
C improve
D none of the above
In a sample of 50 people, 19 had type O blood, 22 had type A blood, 7 had type B blood and 2 had type AB blood. If a person is selected randomly, find the probability that the person has neither type A nor type O blood?
A 15/25
B 31/50
C 11/25
D 9/50
Type 1 workers can do three times the work of Type 2 workers. Twelve Type 1 workers can complete a task in 10 days. How many days would it have taken 4 Type 1 and 8 Type 2 workers to complete the same task?
A 16
B 17
C 20
D 18
A company produces five types of shirts -- A,B,C,D and E-using cloth of three qualities -- high, medium and low , using dyes of three qualities-- high, medium and low. One shirt requires 1.5 m of cloth .The following table gives respectively : The number of shirts (of each category) produced, in thousands. The percentage distribution of cloth quality in each type of shirt, and The percentage distribution of dye quality in each type of shirt. What is the ratio of low quality dye used for C-type shirts to that used for D-type shirts ?
A 2:3
B 1:2
C 2:1
D 3:2

Next steps