Related Questions

The length of a rectangular field F is 3 km greater than the side of a square field M , and the width of field F is 3 km less then the side of field M. If the area of field M is m2 square km, what is the area of field F?
A m2 +6
B 6
C m2 - 6
D m2 +9
A farmer has two rectangular fields. The larger field has twice the length and four times the width of the smaller field. If the smaller field has area K, then the area of the largest field is greater than the area of the smaller field by what amount?
A 4K
B 6K
C 7K
D 8K
A farmer has two rectangular fields. The larger field has twice the length and four times the width of the smaller field. If the smaller field has area K, then the area of the larger field is greater than the area of the smaller field by what amount ?
A 2K
B 5 K
C 6K
D 7K
________ cooling is the process of dissipating the armature and field winding losses to a cooling medium circulating within the winding insulation wall
A Direct
B Indirect
C Conventional
D Any of the above
A capacitor and a resistor are connected in series to a sine wave generator. The frequency is set so that the capacitive reactance is equal to the resistance and, thus, an equal amount of voltage appears across each component. If the frequency is increased
A VR > VC
B VC > VR
C VR = VC
D VR and VC = 0
A farmer has two rectangular fields. The larger has twice the length and four times the width of the smaller field. If the smaller field has area k, then the area of the larger field is greater than the area of the smaller field by what amount?
A 2k
B 6k
C 7k
D 8k
A farmer has two rectangular field. If the smaller field has area K, then the area of the larger field is greater than the area of the smaller field by what amount?
A 2K
B 7K
C 8K
D 12K
For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f.?
A Lap winding
B Wave winding
C Either of (A) and (B) above
D Depends on other features of design
The winding resistance of a coil can be increased by
A Increasing the number of turns
B Using a thinner wire
C Changing the core material
D Increasing the number of turns or using thinner wire
Some wire- wound resistors have bifilar winding. This type of winding is used to
A Increase the thermal stability
B Reduce the tolerance
C Reduce the inductance of winding
D Double the power rating of the resistor

Next steps