Related Questions

Rashna Company collected the following data in its accounting records in 2014 : From the income statement : Depreciation expense Tk. 1,000 Loss on sale of equipment 3,000 From the comparative balance sheet : Beginning balance , equipment Tk. 12,500 Ending balance , equipment 8,000 Beginning balance , accumulated depreciation 2,000 Ending balance , accumulated depreciation 2,400 No new equipment was purchased during the year. The equipment was sold at the end of the year. What was the cash in -flow from the sale of equipment in 2014?
A Tk, 3,900
B Tk. 1,000
C Tk. 900
D Tk. 600
The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
A Equal to
B Less than
C More than
D None of these
Low helix angle drills are preferred for drilling holes in
A Plastics
B Copper
C Cast steel
D Carbon steel
Increasing the original price of an item by 15 percent and then increasing the new price by another 15 percent is equivalent to increasing the original price by
A 32.25%
B 31.00%
C 30.25%
D 35.54%
Increasing the original price of an article by 15 percent and then increasing the new price by 15 percent is equivalent to increasing the original price by --
A 32.25%
B 31.00%
C 30.25%
D 30.00%
Increasing the original price of an article by 15 percent and then increasing the new price by 15 percent is equivalent to increasing the original price by ---
A 32.25%
B 31.00%
C 30.25%
D 30.00%
What does the underlined word mean in the following sentence?The old man's house, badly in need of paint, was leaning to one side and had holes in the roof, but one side and had holes in the roof, but
A poorly built
B old-fashioned
C run down
D dirty
An intrinsic semiconductor has some holes in it at room temperature. What causes these holes?
A Doping
B Valence electrons
C Free electrons
D Thermal energy
E None of the above
Arrange the following size reduction equipment in the decreasing order of the average particle size produced by each of them.
A Jaw crusher, Ball mill, Fluid energy mill
B Ball mill, Jaw crusher, Fluid energy mill
C Fluid energy mill, Jaw crusher, Ball mill
D Fluid energy mill, Ball mill, Jaw crusher
Which of the following lining material is useful for shield driven tunnels in sub aqueous regions?
A Stone masonry
B Timber
C Cast iron
D Cement concrete

Next steps