Related Questions

A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A tailor had a number of shirt pieces to cut from some large pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute . How many large pieces would be cut in 24 minutes?
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?
A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?
In the blast furnace, incorporation of water vapour in the blast gives the following effect.
Thermal efficiency of blast furnace stoves used for heating blast (air) may be about __________ percent.
If it takes 50 workers 4 hours to dig a hole, how long should it take 30 workers to dig the same hole?
If it takes 4 hours to dig a hole by 50 workers, how long should it take to dig the same hole by 30 workers?
Of the following , which is a hole that could be the empty hole ?
দেওয়া আছে (i) অর্ধপরিবাহীর Majority carrier election, (ii) p-type অর্ধপরিাবাহীর Majority carrier hole এবং (iii) pure অর্ধপিরবাহীর Majority carrier hole । নিচের কোনটি সঠিক?