Related Questions

You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?
A The routing tables on the switches will not update
B The MAC forward\/;filter table will not update on the switch
C Broadcast storms will occur on the switched network
D The switches will automatically load-balance between the two links
A four-person crew from Classic Colors is painting Mr. Field's house. Michael is painting the front of the house. Ross is in the alley behind the house painting the back. Jed is painting the window frames on the north side, Shawn is on the south. If Michael switches places with Jed, and Jed then switches places with Shawn, where is Shawn?
A in the alley behind the house
B on the north side of the house
C in front of the house
D on the south side of the house
For the purpose of track maintenance, the number of turn out equivalent to one track km are
A 1
B 2
C 5
D 10
Chips are made up of millions of tiny parts/switches known as
A etches
B transistors
C charges
D electrons
Chips are made up of millions of tiny parts/switches known as-
A etches c
B electrons
C transistors
D charges
A, B, C, D, E and F are sitting around a circular table in clockwise manner, Now, A and D alter their positions with each other; C switches over to E's seat; E to B's and B to C's If finally, F and D exchange seats, what is the ultimate sequence of sitting in clockwise order?
A FBEACD
B FEBACD
C FEBADC
D FBEADC
Routers operate at layer _____. LAN switches operate at layer _____. Ethernet hubs operate at layer _____. Word processing operates at layer _____.
A 3, 3, 1, 7
B 3, 2, 1, none
C 3, 2, 1, 7
D 3, 3, 2, none
E All of the above
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?
A STP
B VTP
C DHCP
D ISL
Electrical contact materials used in switches, brushes, relay must possess
A High thermal conductivity and high melting point
B Low thermal conductivity and low melting pointL
C High thermal conductivity and low melting point
D Low thermal conductivity and high melting point
Switches and relays should be shown in this position with no operating force or applied energy:
A Normal
B Closed
C Offset
D Application

Next steps