Related Questions

The minimum recommended diameter of sewers, is
A 5 cm
B 10 cm
C 15 cm
D 20 cm
The maximum diameter of sewers adopted in the designs is
A 1.0 m
B 2.0 m
C 3.0 m
D 4.0 m
For large sewers, maximum distance between manholes may be
A 50 m
B 100 m
C 200 m
D 300 m
An instrument to be used for measurement and control should preferably have
A Dead zone and dead time
B Linear output and fast response
C Non-linear output
D A highly damped response
High pressure fluid in a shell and tube heat exchanger should preferably be routed through the
A Tubes to avoid the expansion of high pressure shell construction
B Shell side for smaller total pressure drop
C Shell side, if the flow is counter-current and tube side if the flow is co-current
D Shell side for large overall heat transfer co-efficient
Which of the following sections should preferably be used at places where torsion occurs?
A Angle section
B Channel section
C Box type section
D Any of the above
Angle of inclination of the lacing bar with the longitudinal axis of the column should preferably be between
A 10° to 30°
B 30° to 40°
C 40° to 70°
D 90°
Borrow pits should preferably be located in
A Field on the left side of the canal
B Field on the right side of the canal
C Fields on both sides of the canal
D Central half width of the section of the canal
A raingauge should preferably be fixed
A near the building
B under the tree
C in an open space
D in a closed space
Holes in a plate for rivetted joints is preferably made by
A Drilling
B Tapping
C Reaming
D Punching

Next steps