Related Questions

A column is known as a long column if the slenderness ratio is
A 40
B 50
C 70
D 100
An R.C.C. column is treated as short column if its slenderness ratio is less than
A 30
B 35
C 40
D 50
Euler’s formula for a mild steel column is not valid if the slenderness ratio is
A 90
B 60
C 120
D 100
For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for buildings constructed in
A Zone I only
B Zone I and II
C Zone I, II and III
D Zone I, II, III and IV
Slenderness ratio of a long column, is
A Area of cross-section divided by radius of gyration
B Area of cross-section divided by least radius of gyration
C Radius of gyration divided by area of cross-section
D Length of column divided by least radius of gyration
The slenderness ratio of a column supported throughout its length by a masonry wall is
A Zero
B 10
C 100
D Iinfinity
An R.C.C. column is treated as long if its slenderness ratio is greater than
A 30
B 35
C 40
D 50
There are two domains on your network. The DESIGN domain trusts the SALES domain. A color printer is shared in the DESIGN domain, and print permissions have been granted to the Domain Users and Domain Guests groups in the DESIGN domain. The Guest account has been enabled in the DESIGN domain. User John Y logs on using his account in the SALES domain. What must you do to allow JohnY to access the printer?
A Make JohnY a member of the DESIGN Domain Guests group
B Make JohnY a member of the DESIGN Domain Users group
C Do nothing. JohnY can access the printer now
D JohnY cannot access the printer with this configuration
E None of the above
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
A 180
B 200
C 250
D 350
If the resultant of two equal forces has the same magnitude as either of the forces, then the angle between the two forces is
A 30°
B 60°
C 90°
D 120°

Next steps