Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

If R and T are rise and tread of a stair spanning horizontally, the steps are supported by a wall on one side and by a stringer beam on the other side, the steps are designed as beams of width
If T and R are the tread and rise of a stair which carries a load w per square metre on slope, the corresponding load per square metre of the horizontal area, is
Consider the following statements and choose the correct answer:
1. A direct proportionality exists between vapour pressure and the concentration of water vapour in the atmosphere
2. Relative humidity is an expression of the ratio of the actual vapour pressure of the atmosphere when saturated at the same temperature
3. A rise or fall in temperature with no change in vapour pressure will cause a drop or rise, respectively, in relative humidity
4. A rise or fall in vapour pressure with no change in temperature will be accompanied by a rise or fall, respectively, in relative humidity
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise -fall periods and rise and fall periods should be same. The maximum rise in follower is 30 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 55 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within first half of cam profile, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 35 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
Which of the following is/are incorrect about a staircase? (i) String is the part of tread which is projecting beyond the face of the riser (ii) Soffit is a sort of additional moulding provided under the nosing or tread to beautify the step in elevation (iii) Baluster is a member supporting the handrail (iv) Newel post is a vertical member at the ends of flights
The outer projection on the tread of a stair is: