Related Questions

In ultrasonic machining, tool is made of
A Tungsten carbide
B Brass or copper
C Diamond
D Stainless steel
In electro discharge machining, tool is made of
A Brass
B Copper
C Copper tungsten alloy
D All of these
The angle made by the face of the tool and the plane parallel to the base of cutting tool is called
A Rake angle
B Cutting angle
C Clearance angle
D Lip angle
Which of the following statement is correct about hot machining?
A It requires less power than machining metals at room temperature.
B The rate of tool wear is lower.
C It is used for machining high strength and high temperature resistant materials.
D All of the above
In hot machining, the work is heated by
A Simple heating
B Flame heating
C Induction heating
D Any one of these
For machining a mild steel workpiece using carbide tool, the maximum material will be removed at a temperature of
A 500
B 1000
C 1750
D 2750
For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is
A 5 m/min
B 10 m/ min
C 15 m/min
D 30 m/min
For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is
A 10 m/min
B 15 m/min
C 22 m/min
D 30 m/min
The tool material, for faster machining, should have
A wear resistance
B red hardness
C toughness
D all of the mentioned
When the cutting edge of the tool is dull, then during machining
A Continuous chips are formed
B Discontinuous chips are formed
C Continuous chips with built-up edge are formed
D No chips are formed

Next steps