Related Questions

The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If the maximum number of valves that can be closed at the same time are closed which of the following must true?
A R is open
B S is open
C T is open
D Z is open
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If R is closed and U is open, which of the following must be true?
A S is open
B T is open
C T is closed
D Y is closed
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If Z is open, which of the following must be true?
A S is open
B T is open
C U is open
D y is open
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
The pressure ratio for an open cycle gas turbine compared to closed cycle gas turbine of same h.p. is
A Low
B High
C Same
D Low/high depending on make and type
A closed cycle gas turbine gives ________ efficiency as compared to an open cycle gas turbine.
A Same
B Lower
C Higher
D None of these
In self cooled motors the cooling time constant is about ______ than the heating time constant because cooling conditions are worse at standstill.
A 2 to 3 times greater
B 3 to 4 times greater
C 4 to 5 times greater
D none of the above
Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the __________ temperature of air.
A Wet bulb
B Dry bulb
C Saturation
D Dew point
Noise produced by cooling fans (employed in air cooled heat exchangers or cooling tower) is mainly caused due to the turbulence created by blade passage through air. It can be reduced by use of a slower fan
A With greater number of blades
B Of increased diameter
C Both A & B
D Neither A nor B
In closed cycle gas turbine, the air is compressed
A Isothermally
B Isentropically
C Polytropically
D None of these

Next steps