Related Questions

The divergent portion of a Venturimeter is made longer than convergent portion in order to
A Avoid the tendency of breaking away the stream of liquid
B To minimize frictional losses
C Both (A) and (B)
D None of these
The discharge of steam in a convergent-divergent nozzle __________ after the throat (i.e. in the divergent portion of the nozzle)
A Remains constant
B Decreases
C Increases
D None of these
The pressure of the liquid flowing through the divergent portion of a Venturimeter
A Remains constant
B Increases
C Decreases
D Depends upon mass of liquid
The velocity of the liquid flowing through the divergent portion of a Venturimeter
A Remains constant
B Increases
C Decreases
D Depends upon mass of liquid
The exit cone angle in case of a standard venturimeter is __________ the entrance cone angle.
A Smaller than
B Greater than
C Equal to
D Either A or B
Permanent loss in a venturimeter is about __________ percent of the pressure drop in theupstream cone.
A 1
B 10
C 40
D 70
What is the normal range of exit cone angle of a venturimeter?
A 2 to 5
B 7 to 15
C 15 to 25
D >25
When the Venturimeter is inclined, then for a given flow it will show __________ reading.
A Same
B More
C Less
D None of these
The pressure of liquid at throat in a Venturimeter is __________ than that at inlet.
A Higher
B Lower
C Same
D None of these
Venturimeter is used to measure the flow rate of fluids in pipes, when the pipe is in __________ position.
A Horizontal
B Vertical
C Inclined
D Any

Next steps