Related Questions

When a cylindrical vessel, containing some liquid, is rotated about its vertical axis, the liquid surface is depressed down at the axis of its rotation and rises up near the walls of the vessel on all sides. This type of flow is known as
A Steady flow
B Turbulent flow
C Vortex flow
D Uniform flow
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
A 0.5 D
B D
C 1.5 D
D 2 D
A closed rectangular tank contains a certain amount of water. When the tank is placed on its 3 ft by 4 ft side, the height of the water in the tank is 5 ft . Wen the tank is placed on another side of dimensions 4 ft by 5 ft , what is the height, in feet,
A 3 feet
B 5 feet
C 6 feet
D 4 feet
The distillation carried out in such a way that the liquid with the lowest boiling point is first evaporated and re-condensed, then the liquid with the next higher boiling point is then evaporated and re-condensed, and so on until all the available liquid fuels are separately recovered in the sequence of their boiling points. Such a process is called
A Cracking
B Fractional distillation
C Full distillation
D Carbonisation
Two tanks are filled to capacity with automobile fuel. The first tank holds 600 gallons more than the second tank. If 100 gallons were to be pumped from each tank, the first tank would then contain 3 times as much fuel as the second tank. What is the total number of gallons of fuel in the two full tanks?
A 1,400
B 1,200
C 1,000
D 900
A tank is fitted with 8 pipes, some of them that fill the tank and others that are waste pipe meant to those that empty the tank can empty it in 6 hours. If all the pipes are kept open when the tank is full, it will take exactly 6 hours for the tank to empty. How many of these are these are fill pipes?
A 2
B 4
C 6
D 5
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank?
A 33.5%
B 37.5%
C 40%
D 50%
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank ?
A 33.5%
B 37.5%
C 40%
D 50%
A tank filled partially with a liquid is subjected to a uniform horizontal acceleration. Which of the following is true for the surface of liquid in the tank?
A The liquid surface falls down on the direction of motion and rises up on the back side of the tank
B The liquid surface falls down only at the center of the tank
C The surface of the liquid remains horizontal
D None

Next steps