Related Questions

Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
A Heat transfer co-efficient are high
B There is no risk of contamination
C There is no mist formation
D Cost of equipment is lower
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
The temperature in a home freezer varies from 25 degree F to 3 degree F. What is the difference, in Celsius, between these two temperatures?
A 28
B 22
C 27
D 23
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
একটি কর্নো ইঞ্জিন 500 K এবং 205 K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে 1 kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250K. If the engine receives 1 kcal of heat from the source in each cycle, the amount of heat rejected to the sink in each cycle is-)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
একটি কার্নো ইঞ্জিন 500K এবং 250K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে । kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250 K. If the engine receives 1 kcal of heat from the source in cach cycle, the amount of heat rejected to the sink in each cycle is --)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
The minimum temperatures from Monday through Sunday in the first week of December in a region are observed to be 20c,40c,40c,50c,70c90c,100c. What is the range of the temperatures?
A -100c
B -80c
C 80c
D 100c
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
A Less than
B 1.25-1.50 times
C 2.5 times
D One-fourth of
The use of heat exchangers is made in
A Radiators in automobile
B Condensers and boilers in steam plants
C Condensers and evaporators in refrigeration and air conditioning units
D All of the above
Multipass heat exchangers are used
A Because of simplicity of fabrication
B For low heat load
C To obtain higher heat transfer co-efficient and shorter tube
D To reduce the pressure drop

Next steps