Related Questions

The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be
A Same in both cases
B 2 times more
C 3 times more
D 4 times more
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
If there is a circular hole in a metal plate, what happens to the radius of the hole when the plate is heated?
A Increases
B Decreases
C Unchanged
D Depends upon the metal
A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole ?
A Increase
B Dacrease
C Remain constant
D Will increase first and then dcrease
When a bar of length '$$l$$' and diameter 'd' is rigidly fixed at the upper end and hanging freely, then the total elongation produced in the bar due to its own weight is (where w = Weight per unit volume of the bar)
A $$\frac{{{\text{w}}l}}{{2{\text{E}}}}$$
B $$\frac{{{\text{w}}{l^2}}}{{2{\text{E}}}}$$
C $$\frac{{{\text{w}}{l^3}}}{{2{\text{E}}}}$$
D $$\frac{{{\text{w}}{l^4}}}{{2{\text{E}}}}$$
The motion of a shaft in a circular hole is an example of
A completely constrained motion
B incompletely constrained motion
C successfully constrained motion
D none of the mentioned
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
If it takes 50 workers 4 hours to dig a hole, how long should it take 30 workers to dig the same hole?
A 2 hrs, 24 mins
B 6 hrs, 12 mins
C 5 hrs, 12 mins
D 6 hrs, 40 mins
If it takes 4 hours to dig a hole by 50 workers, how long should it take to dig the same hole by 30 workers?
A 2 hours 24 minutes
B 6 houres 12 minutes
C 5 houres 12 minutes
D 6 hours 40 minutes
Of the following , which is a hole that could be the empty hole ?
A 1
B 2
C 4
D 6

Next steps