Bissoy.com
Doctors Medicines MCQs Q&A

Which one of the following statements about differential pulse code modulation (DPCM) is true?

Which one of the following statements about differential pulse code modulation (DPCM) is true? Correct Answer The difference of message signal sample with its prediction is quantized

Related Questions

Consider the following types of modulation: 1. Amplitude modulation 2. Frequency modulation 3. Phase modulation 4. Pulse modulation Which of the above modulation are used for telecasting TV programs?
Consider the following: 1. Pulse-position modulation. 2. Pulse-code modulation. 3. Pulse-width modulation. Which of the above communications are not digital?
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
Two processes X and Y need to access a critical section. Consider the following synchronization construct used by both the processes Process ? /* other code for process ? */ while(true) { varP = true; while(varQ == true) { /* Critical Section */ varP = false; } } /* other code for process ?? */   Process ? /* other code for process ? */ while(true) { varQ = true; while(varP == true) { /* Critical Section */ varQ = false; } } /* other code for process ? */   Here, varP and varQ are shared variables and both are initialized to false. Which one of the following statements is true?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
In case of a single-pulse width modulation with the pulse width = 2d, to eliminate the 3rd harmonic from the output voltage waveform, the value of the pulse width (2d) must be
In case of a single-pulse width modulation with the pulse width = 2d, to eliminate the 5th harmonic from the output voltage waveform, the value of the pulse width (2d) must be equal to
The figure shows the plot of y as a function of x
Differential Equations mcq question image
The function shown is the solution of the differential equation (assuming all initial conditions to be zero) is
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface