Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The figure below shows a circuit for an AC voltmeter. It utilizes a moving-coil meter that gives a full-scale reading when the average current flowing through it is 1 mA. The moving-coil meter has a 50-Ω resistance. The value of R that results in the meter indicating a full-scale reading when the input sine-wave voltage VI is 20 V peak-to-peak is
Consider the following statements regarding electronic voltmeter. 1) The detection of low-level signals is not possible using the electronic voltmeter 2) MOSFET is used at the input of the electronic voltmeter 3) Vacuum tube voltmeters (VTVM) consumes more power as compared to any non-electronic voltmeter. Which of the following is / are incorrect?
একটি স্টেপ আপ ট্রান্সফরমারে, গৌণ কুণ্ডলীর পাকসংখ্যা মুখ্য কুন্ডলীর পাকসংখ্যার দ্বিগুণ। যদি মূখ্য কুন্ডলীকে কোন পরিবর্তী বিদ্যুৎ লাইনের সাথে সংযুক্ত করা হয়, তাহলে মুখ্য কুণ্ডলীর তুলনায় গৌণ কুণ্ডলীতে- (In a step up transformer, the number of turns in the secondary coil is twice to that of primary coil. If you apply an alternating current in the primary coil, then in the secondary coil compared to the primary coil-)
You have a 2 milliampere meter movement with a coil resistance of 1000 ohms. When 2 milliampere is flowing through the meter coil and is causing FSD, what will be the voltage developed across the coil resistance?
A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
The figure shows the circuit of a rectifier type voltmeter. The diode D2 1. Does not allow any current to flow through the meter durign negative half cycle. 2. Does not allow reverse leakage current to flow through the meter during negative half cycle. 3. Short circuits the meter during negative half cycle. Which of these statements are correct?
When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
A large circular coil of N turns and radius R carries a time varying current $$I = {I_0}\sin \left( {\omega t} \right).$$   A small circular coil of n turns and radius r(r ≪ R) is placed at the centre of the large coil such that the coils are concentric and coplanar. The induced emf in the small coil
A moving coil of a meter has 250 turns and a length and depth of 40 mm and 30 mm respectively. It is positioned in a uniform radial flux density of 450 mT. The coil carries a current of 160 mA. The torque on the coil is?
The input impedance of the permanent magnet moving coil (PMMC) voltmeter is infinite. Assuming that the diode shown in the figure below is ideal, the reading of the voltmeter in Volts is