Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The Transfer characteristic of the different types of MOSFETs is shown below, where ID is drain current and VGS is the Gate-Source voltage, the correct combination of MOSFET w.r.t to transfer characteristics is: Types of MOSFET (P) P – Channel Enhancement MOSFET (Q) P – Channel Depletion MOSFET (R) N – Channel Enhancement MOSFET (S) N – Channel Depletion MOSFET
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
Consider four processes P, Q, R, and S scheduled on a CPU as per round-robin algorithm with a time quantum of 4 units. The processes arrive in the order P, Q, R, S, all at time t = 0. There is exactly one context switch from S to Q, exactly one context switch from R to Q, and exactly two context switches from Q to R. There is no context switch from S to P. Switching to a ready process after the termination of another process is also considered a context switch. Which one of the following is NOT possible as CPU burst time (in time units) of these processes?  
For the circuit as shown, consider that switch S1 has been in position B for a very long time and switch S2 has been open all the time. At time t = 0, the switch S1 moves to position A and switch S2 closes instantaneously. What is the value of Vout of t = 0+, assuming initial charge on C = 0?
Which of the following types of connections can use full duplex?
1. Hub to hub
2. Switch to switch
3. Host to host
4. Switch to hub
5. Switch to host
The N-channel MOSFET is considered better than the P-channel MOSFET due to its
In which of the following cases, MOSFET is helpful? (I) Switch for LED (II) Switch with hysteresis (III) Switching Solenoid
If beginning work in process equivalent units are 2500 units, work done in current period equivalent units are 3800 units and ending work in process equivalent units are 5000, then complete equivalent units in current period are
The depletion type MOSFET is equivalent to normally closed switch.