Related Questions

Which of the following TTL subfamily is the fastest
A standard TTL
B high-speed TTL
C schottky TTL
D low-speed TTL
E None of the above
The maximum number of TTL loads that a TTL device can drive reliably over the specified temperature range is
A fanout
B bipolar
C chip
D universal logic circuit
E None of the above
Standard TTL has a multiple emitter input transistor and a _____ output
A totem-pole
B bipolar
C register
D transistor
E None of the above
Which of the following technique is used for Time-To-Line (TTL)?
A a technique used in best-effort delivery system to avoid endlessly looping packets.
B a technique used by protocols in which a lower level protocol accepts a message from a higher level protocol and places it in the data portion of the low level frame
C One of the pieces that results when an IP gateway divides an IP datagram into smaller pieces for transmission across a network that cannot handle the original datagram size.
D All of the above
E None of the above
What is TTL?
A Technical Talk Language
B Transparent Transfer Layer
C Time To Live
D True Technology Lives
The coefficient of fluctuation of speed is __________ of maximum fluctuation of speed and the mean speed.
A Sum
B Difference
C Product
D Ratio
The respective ratio between the speed of a speed of the car, bus and train is 5 : 9 : 6. The average speed of the car, bus and train is 72 km/hr together. What is the average speed (km/h)of the car and the train together?
A 82
B 72
C 67
D 84
Jamil can run 1 km in 4 minute. Heas a car that has a top speed of 75 km/hour . Jamil's speed id what percentage of his top speed?
A 10%
B 20%
C 25%
D 30%
The ratio of maximum fluctuation of speed to the mean speed is called
A fluctuation of energy
B maximum fluctuation of energy
C coefficient of fluctuation of speed
D none of the mentioned
The cutting speed is maximum while machining _________ with a high speed steel tool.
A Cast iron
B Mild steel
C Brass
D Aluminium

Next steps