Related Questions

A software requirement specification is : i) A contract between developers and clients specifying what the developers will produce for the clients. ii) A specification of the features that the target software deliverable must have iii) A specification of the personal and resources that will be committed to the software development effort
A i only
B ii only
C i and ii only
D i and iii only
Suppose half the passengers on a bus exit at each stop and no additional passengers board the bus. If on the fourth stop, the next to the last person exits the bus, how many people were on the bus at the beginning?
A 64
B 32
C 40
D 20
If Zara walks at 5 km/hr, she reaches the bus stop 5 minutes late and if she walks at 6 km/hr , she reaches the bus stop 5 minutes earlier . The bus stop is at a distance of -
A 3 km
B 5 km
C 6 km
D 10 km
A bus uses one gallon of gasoline to travel 15 miles.After a tune-up,the bus travels 15% farther on one gallon. How many gallons of gasoline (to the nearest tenth) will it takes for the bus to travel 150 miles after a tune-up?
A 8.7
B 8.5
C 8.9
D 9
A bus picks up a group of tourists at a hotel. The sightseeing bus travels 2 blocks north, 2 blocks east. I block south, 2 blocks east, and 1 block south. Where is the bus in relation to the hotel?
A 2 blocks north
B 1 block west
C 3 blocks south
D 4 blocks east
when Alex got on the school bus , there were 3 other children got on the bus. How many children were now on the bus?
A 6
B 7
C 8
D 3
When Alex got on the school bus, there were 3 other children on the bus. At the next stop 3 more children got on the bust. How many children were now on the bus?
A 6
B 7
C 8
D 3
Which provides the fastest data access time?
A RAM
B ROM
C CD-ROM
D Hard disk
E Floppy disk
A certain hard disk has a data transfer rate of 20 MB/sec. How much time is required to transfer 5 megabyte data from this disk to memory?
A 20 sec.
B 1 sec.
C 0.5 sec.
D 0.25 sec.
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base

Next steps