A first order gaseous phase reaction is catalysed by a non-porous solid. The kinetic rate constant and the external mass transfer co-efficients are k and $${{\text{k}}_{\text{g}}}$$ respectively. The effective rate constant (keff) is given by

A first order gaseous phase reaction is catalysed by a non-porous solid. The kinetic rate constant and the external mass transfer co-efficients are k and $${{\text{k}}_{\text{g}}}$$ respectively. The effective rate constant (keff) is given by Correct Answer $$\frac{1}{{{{\text{k}}_{\text{e}}}{\text{ff}}}} = \frac{1}{{\text{k}}} + \frac{1}{{{{\text{k}}_{\text{g}}}}}$$

Bissoy MCQ

Related Questions

For the reaction, A = X + Y, the respective concentrations are CA, CX and CY. The forward reaction rate constant is kf and the backward reaction rate constant is kb. Choose the correct statement from the following:
P. At equilibrium, kf CA > kB CxCy
Q. If the reaction is irreversible than, kb CXCY = 0
R. The backward reaction rate will essentially be first order, if the forward reaction rate is first order.
S. Activation energy for the first order forward reaction will be independent of temperature.
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
What is the monoisotopic and average mass of valine? Given data: Mass of the most abundant isotope of Carbon (C°)=12.0000, Mass of most abundant isotope of Hydrogen (H°)=1.0078, Mass of most abundant isotope of Oxygen (O°)=15.9949, Mass of most abundant isotope of Nitrogen (N°)=14.0031, The average mass of Carbon (C)=12.011, The average mass of Hydrogen (H)=1.008, The average mass of Oxygen (O)=15.999, The average mass of Nitrogen (N)=14.007.
Rate constant for a first order reaction does not depend upon reaction time, extent of reaction and the initial concentration of reactants ; but it is a function of reaction temperature. In a chemical reaction, the time required to reduce the concentration of reactant from 100 gm moles/litre to 50 gm moles/litre is same as that required to reduce it from 2 gm moles/litre to 1 gm mole/litre in the same volume. Then the order of this reaction is
A reaction which is catalysed by an acid is also catalysed by any substance, which has a tendency to
A reaction which is catalysed by a base is catalysed by all substances which have a tendency to
A first solid phase results in a second solid phase another third solid phase on cooling during __________ reaction.
Consider a given volume of liquid at a temperature T below Tm with a free energy G’. If some of the atoms of the liquid cluster together to form a small sphere of solid, the free energy of the system will change to G, given by________ (Assume V1 volume of the solid sphere, V2 volume of liquid, A is the solid/liquid interfacial area, γ solid/liquid interface free energy, G1 and G2 are the free energies per unit volume of solid and liquid respectively).
A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids)
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where: